Motor Guide Results
Here is your handy guide to the motors that might work with your rocket. We found 58 motors that fit and appear to have enough thrust (667 motors didn't fit, 80 motors failed safety checks). 138 motor had thrust curves available and 286 flight simulations were performed. Browse the motors that did and didn't work right here or download the results as a spreadsheet.
Motors That Work
These motors fit your rocket and appear to have enough thrust to lift it safely. If thrust curves are available, a quick simulation has been run to give a rough idea of the performance of your rocket on this motor. We encourage you to run a more complete simulation with any motor you plan to use; see the simulators page for more info.
W Motor total weight unknown, lift-off Weight not accurate.
Motors That Fail
These motors fit your rocket, but failed one safety check or another. They may actually work, but you should use them only with caution. We encourage you to run a more complete simulation to verify flight safety; see the simulators page for more info.
G These simulations were run with a launch guide length of 6ft (rod, rail or tower). If this is not correct, launch guide lengths can be specified for your saved rockets. (The minimum velocity required is approximately 15m/s or 50ft/s.)
A The minimum altitude check is used to ensure that the rocket flies high enough to ensure time for a safe recovery. In addition, many barometric altimeters require a minimum altitude to detect lift-off. (The minimum altitude is 10m or 33ft for an A motor and doubles for each impulse class).
Download the Results
The data is presented in a compact form in the tables above, broken down by motors that worked and those that did not. If you would like to analyze the data further, this section provides download links for files in a generic spreadsheet format (comma-separated value, or CSV) that can be opened with almost any spreadsheet program.
You should download these files to your machine and then open them. Normally, clicking the link will prompt you to do this. However, if your browser insists on opening the file as plain text, you can right-click (control-click on the Mac) on the link and chose Save File As (or similar).